Adhesive Strips - Instructions
Adhesive Strips are made of Polyacrylate produced according to clinical standards.
|
They are neutral to the skin and especially:
- hypoallergenic
- very thin and moulding to the skin surface
- impermeable to liquids (i.e. during bathing)
- transparent and invisible while being used
- sterilisable
|
 |
Handling
1. Please clean the skin-surface where the Adhesive Strips shall be attached with a
mild cleaning lotion. The skin should be dry and free of grease.
2. Remove the white protective film first. For an easy removal this white film has an
adhesive-free area in one side. Please take both parts of the green (may be two white
instead of green) protective film between thumb and forefinger like it is shown below.
3. Now fix the Adhesive Strips on the rear side of your breast form. To
assure the safe fitting of the breasts form, The Adhesive Strips should be placed near the
borders - as it is described in the following example.
In order to determine the most effective placing for the Adhesive Strips,
you can chose between 2 different shapes. Size 1 is the entire strip. Size 2 is just cut
from the whole strip.
4. Please determine the right fit of your breast form in front of the
mirror. In the beginning it may help to mark some points of the breast form upon the skin
with a pencil. After that please remove both green protective films and fix the breast
form according to the marks. Within 30 seconds the Adhesive Strips reacts with the body
heat and sticks to the skin surface.
In the following hours you can be active in a light bra or a bathing suit
without taking care of your breast form.
5. To remove the breast form, please tear it in a flat angle slightly from
the body. The Adhesive Strips will not leave any residue on or irritation of you skin.
Finally remove the Adhesive Strips from the breast form, which you can
wear as usual now.
|
View Shopping Cart